REVERSE COMPONENTS Travel and Sag Indicator 2.0
The Travel and Sag Indicator is a small yet very useful tool for optimizing the setup of your coil shock on your new bike or for the next race. On the one hand, you can use it to read off the required spring travel in order to determine the optimum spring rate. At the same time, you can determine the "sag" (negative spring travel) and the spring preload. This allows you to find out quickly and easily whether your spring rate or compression level/damping is set correctly.
The Travel and Sag Indicator is attached to the side of the shock, the design allows for permanent use.
Note: Use the enclosed installation instructions to install the Travel and Sag Indicator. It is only compatible with springs that do not exceed a length of 180 mm, whether compressed or uncompressed. The pictured damper is used to illustrate the application and is not part of the scope of delivery.
Technical data:
Material: aluminum, plastic
Compatibility: all common steel spring dampers
Weight according to manufacturer: 40g
Weight when weighed: 33g
Scope of delivery:
1x upper spring plate attachment
1x lower spring plate attachment
1x holder for the indicator
1x telescopic sleeve
1x telescopic scale
2x M3 screw
2x Self-locking nut M3
1x M5 serrated lock washer
1x screw M5
1x O-ring