SRAM RED Etap Aero switching groups Set Upgrade Kit
On the Road switch as in the Formula 1?
The wireless SRAM Red Etap switching components make it possible. Tap a switching button to the right to switch to a faster transition, a switch button on the left to switch to an easier gear and turn the front derailleur both levers together. The Aero Group also has a pair of additional push buttons for the aero bar. But not only the switching logic of the ETAP group has been consistently developed with the aim of simplification, but also the installation of the components is a breeze. Without cables the RED ETAP is mounted in a very short time and ensures a tidy appearance at the wheel. Then, still couple the components together and there you go. To prevent interference during data transmission, Sram has AIREA network develops. The stand-alone system is not compatible with ANT +, Bluetooth or WiFi and guarantees maximum with a 128 bit encryption switching reliability.
The 4 control buttons can be mounted depending on personal preferences on handlebars and the aero bar. So you can, depending on the driving situation, always be in the optimum position on the bike and a gripping of the aero bar is no longer necessary to turn.
The Blipbox is the control module of ETAP Aero Group. At her 4 Blip switches are connected and sparked your switching commands via AIREA communication protocol for rear derailleur and derailleur.
The clean design, the cage made of carbon and ceramic bearing jockey wheels make the Etap derailleur to a real gem. Setting can be derailleur comfortably in 0.2 millimeter increments over a button on the gear lever. Equipped with an additional ANT + transmitter, it can in the future communicate with bike computers and information about the battery charge status and the current gear can be displayed.
Equipped with the developed SRAM Yaw Technology is a trim of Etap derailleur not necessary. Due to the special suspension the baffles describe when switching a slight curve, instead of moving parallel to the chain. Thus, the baffles are in a better angle to the chain and a grind is not possible. For the best possible function of the derailleur has been optimized for use with SRAM X-glider 11-speed chainrings. it is positioned above the established limit 2 screws for the upper and lower stop. For installation work or in case of a defect lever of the switching operation can be performed directly on the front derailleur.
Charger / battery
The built-in battery to derailleur and derailleur have a range of over 1,000 kilometers. The state of charge can be read on LED lights at any time. The batteries of derailleur and derailleur are identical and thus the move interchangeably. With the charger included in the delivery, the batteries are fully charged again within an hour.
Material: aluminum, carbon, plastic
Gears: 2x 11
Mounting derailleur: Braze (clip optional)
maximal pinion size cassette: 28 teeth
Battery life: about 1000 Km
Blip Box - 31g
Blips switch buttons - 16g (per pair)
Derailleur - 239g (including battery)
Derailleur - 187g (including battery)
Total weight: 473g
Delivery: Etap Blipbox, 2x pair Etap blips (650 mm length), including battery Etap derailleur, front derailleur Etap including battery, ETAP Battery Charger, Etap USB Stick for firmware updates
NOTE: The SRAM RED Etap switching group you can find in our shop as configurable groupset including brakes, crank and all other drive components.