EASTON bottom bracket PF86 for 30 mm crankshaft
If you drive one of the best cranks on the market, you should also use an optimized bearing. This was Easton's approach to developing the bottom bracket for the EC90 SL crank unit. And so the engineers have tried in numerous tests to find the optimum ratio of good seal and low bearing resistance. Likewise, they experimented with different fat viscosities and levels in the stores until the best result was found. To verify the results, the warehouses were subjected to extensive test series under laboratory conditions and on the road.
The PF86 bearing shells are suitable for crankshafts with 30 mm diameter.
intended use : Road bike, Gravel, Cyclocross
Material bearing shell: aluminum
Material bearing: steel
Bearing Type: PressFit BB86
Inner bearing housing width: 86.5 mm
Inner bearing housing Ø: 41 mm
Crank shaft diameter: 30 mm
Crank wavelength: min. 129 mm
Compatibility crank: Easton EC90 SL crank with 30 mm shaft diameter
Bearings: Industrial bearings with special grease filling
Tool holder: PressFit
Weight: 66g (manufacturer)
Note: For proper installation of the inner bearing, follow the instructions of the manufacturer!