DT SWISS front hub 350 disc 6-hole 15x100 mm thru axle
DT Swiss hubs have a reputation for being almost indestructible. And not without reason. Thanks to high-quality steel industrial bearings and effective seals, DT Swiss hubs are actually significantly more resistant than most of the competitors on the market. Just unpack it, install it in the bike and forget it. The 350 hubs are also extremely user-friendly, so no bearing play needs to be set and the maintenance intervals are only necessary at large intervals, if at all. Should service be necessary after tens of thousands of kilometers, the hubs can be dismantled and serviced within a few minutes thanks to the DT Swiss plug-in system. The flange geometry, which has been tried and tested for years, forms the perfect basis for durable and stiff impellers.
intended use : Cross Country, Marathon, All Mountain, Enduro
Material: aluminum, steel
Installation width: 100 mm
axle type : 15x100 mm thru axle
Number of holes: 28 or 32 holes
Brake disc mount: 6-hole (IS2000)
bearing : 2x steel industrial bearing
Seal: labyrinth rubber seals
Spoke type: Standard spokes (J-Bend)
Spoke tension: 1200N
maximum rider weight: no weight limit
Color: black with white decals
Weight: 172g (manufacturer information)
Scope of delivery: 1x DT Swiss 350 hub 6-hole disc 15x100 thru axle
INFO: DT Swiss 350 front hubs, which are intended for a 15 mm thru axle system (QR15), do not have a continuous axle within the hub body. That means that the ball bearings are directly on the 15 mm thru axle - which one
connect the impeller to the fork. For this reason, most tuning thru axles (e.g. Carbon Ti, Shift Up, Extralite etc.) cannot be used with this type of hub. All tuning thru axles, which are butted on the outside in the middle section, are not suitable because the ball bearings cannot be supported on the thru axle.
You can find detailed operating instructions here .